Featured User: kurt
Open-source hardware project hosting is my passion. I spend most of my free time building neat gadgets or planning what I'll build next. I love building things, and I want to make Open Hardware Hub a place that inspires others to build, ...
Updates 2013 February 18
It's been a while, hasn't it? Well, that's ok because we've got a lot of updates to talk about. Most of these have been effective on the site fora couple weeks now. A few may or may not be active when this article gets posted, but they'll certainly be applied in the ...
Portal Turret Plushie
Deadly, yet adorable, this plush turret from the game Portal talks and responds when you play with it. It senses when you pick it up, knock it over, or walk in front of it. The stuffing and soft fleece skin make it super cuddly, too!
Inspired by Up, not North.
- Portal_Turret.pde - Portal Turret Arduino Sketch
- PIRSensorTest.pde - PIR Sensor Test Arduino Sketch
- WaveShieldTest.pde - Wave Shield Test Arduino Sketch
- test.wav - Test WAV File
- Pattern Page 1.pdf - Rear and Center Pattern
- Pattern Page 2.pdf - Front Pattern
- Pattern Page 3.pdf - Leg and Leg Cover Pattern
Bill of Materials
|Qty||Part #||Description||Schematic ID||Source|
|1||Wave Shield||Adafruit Wave Shield for Arduino Kit - v1.1||Source|
|1||RBBB Kit||Really Bare Bones Board Kit (Arduino Compatible)||Source|
|1||PIR Motion Sensor||PIR Motion Sensor||Source|
|1||SD Card 2 GB||SanDisk 2 GB Class 2 SD Flash Memory Card SDSDB-2048-A11||Source|
|1||TSW-150-07-L-S||CONN HEADER 50POS .100" SGL GOLD||Source|
|1||White Fleece Fabric||1/4 yard||Source|
|1||Red Tulle Fabric||1/8 yard||Source|
|1||Black Cotton Fabric||1/8 yard||Source|
|1||Polyester Fiberfill||12 ounces||Source|
|1||White Zipper||7 inches||Source|
|10||WP7113LID||5MM LOW CURRENT RED LED, LAMP THOLE, BULK||Source|
|1||CF14JT100R||1/4w 100 ohms 5% Carbon Film Resistors||Source|
|1||CF14JT10K0||1/4w 10K ohms 5% Carbon Film Resistors||Source|
|1||BH48AASF||HOLDER BATTERY 8 CELL AA W/SNAP||Source|
Lay out your parts and make sure that you have everything. Clockwise from top left: voltage regulator, switch, LED, 2 resistors, 2 electrolytic capacitors, 2 ceramic capacitors, resonator, power jack, diode, PCB, ATMega328, IC socket, and 3 headers.
Start by inserting the resistors as shown. Bend the leads outwards after you have inserted the resistors so they hold themselves in place.
Insert the two small capacitors into the holes for caps C3 and C4. Bend their legs so they don't fall out when you turn the board upside-down.
15 - added attribution note
14 - updated description
13 - added a couple switches to the parts list
12 - updated steps 52 and 53 to remove "TK" placeholders
11 - added a speaker to the BOM
7 - edited step 130
3 - updated project images.
2 - added youtube link. updated line numbers.
1 - Initial project release
blog comments powered by Disqus