-
Featured User: kurt
Open-source hardware project hosting is my passion. I spend most of my free time building neat gadgets or planning what I'll build next. I love building things, and I want to make Open Hardware Hub a place that inspires others to build, ...
-
Updates 2013 February 18
It's been a while, hasn't it? Well, that's ok because we've got a lot of updates to talk about. Most of these have been effective on the site fora couple weeks now. A few may or may not be active when this article gets posted, but they'll certainly be applied in the ...
Portal Turret Plushie
Files
- Portal_Turret.pde - Portal Turret Arduino Sketch
- PIRSensorTest.pde - PIR Sensor Test Arduino Sketch
- WaveShieldTest.pde - Wave Shield Test Arduino Sketch
- test.wav - Test WAV File
- Pattern Page 1.pdf - Rear and Center Pattern
- Pattern Page 2.pdf - Front Pattern
- Pattern Page 3.pdf - Leg and Leg Cover Pattern
Bill of Materials
This open source hardware project contains no parts.
Steps
131. Print and cut pattern
Print and cut the pattern pieces out for the body. When you print these pieces, make sure to set "Page Scaling" to "None" in the "Print" dialogue box.
132. Cut out fleece pieces
Use a marker to trace the pattern into white fleece, and cut out the pieces. Each panel needs to be cut out twice: once for the left side and once for the right side.
133. Sew right back to right front
Place the right back piece on top of the right front piece so that the top edges are aligned. Stitch this edge together. Repeat for the left side.
134. Sew right center to right front
Open the pieces at the stitch, and align the bottom of the right center piece with the right front piece as shown. Begin to stitch at the aligned edge.
135. Continue sewing right center to right front
Rotate the right center piece to align its long edge to the inside edge of the right front piece. Stitch together this side.
Download steps w/o images
Download steps w/ images
Revisions
15 - added attribution note
14 - updated description
13 - added a couple switches to the parts list
12 - updated steps 52 and 53 to remove "TK" placeholders
11 - added a speaker to the BOM
10 -
9 -
8 -
7 - edited step 130
6 -
5 -
4 -
3 - updated project images.
2 - added youtube link. updated line numbers.
1 - Initial project release
Add revision
blog comments powered by Disqus
Back
