-
Featured User: kurt
Open-source hardware project hosting is my passion. I spend most of my free time building neat gadgets or planning what I'll build next. I love building things, and I want to make Open Hardware Hub a place that inspires others to build, ...
-
Updates 2013 February 18
It's been a while, hasn't it? Well, that's ok because we've got a lot of updates to talk about. Most of these have been effective on the site fora couple weeks now. A few may or may not be active when this article gets posted, but they'll certainly be applied in the ...
Portal Turret Plushie
Files
- Portal_Turret.pde - Portal Turret Arduino Sketch
- PIRSensorTest.pde - PIR Sensor Test Arduino Sketch
- WaveShieldTest.pde - Wave Shield Test Arduino Sketch
- test.wav - Test WAV File
- Pattern Page 1.pdf - Rear and Center Pattern
- Pattern Page 2.pdf - Front Pattern
- Pattern Page 3.pdf - Leg and Leg Cover Pattern
Bill of Materials
This open source hardware project contains no parts.
Steps
. Insert and solder LED
Insert the LED and make sure that the LED's long lead goes in the hole closest to the (+) printed on the circuit board. Bend the leads so the LED stays in place. Solder the LED.
. Insert diode, switch, and regulator
Insert the diode, switch and regulator. There is now wrong way to install the switch. The diode's stripe goes near the hole without a ring around it. The flat side of the regulator goes towards the side of the board.
. Solder LED, diode, switch, and voltage regulator
Solder the LED, diode, switch, and voltage regulator in place.
. Insert capacitors
Insert the two electrolytic capacitors as shown. Note the position of the stripes on the capacitors to make sure they are inserted correctly.
Download steps w/o images
Download steps w/ images
Revisions
15 - added attribution note
14 - updated description
13 - added a couple switches to the parts list
12 - updated steps 52 and 53 to remove "TK" placeholders
11 - added a speaker to the BOM
10 -
9 -
8 -
7 - edited step 130
6 -
5 -
4 -
3 - updated project images.
2 - added youtube link. updated line numbers.
1 - Initial project release
Add revision
blog comments powered by Disqus
Back
