-
Featured User: kurt
Open-source hardware project hosting is my passion. I spend most of my free time building neat gadgets or planning what I'll build next. I love building things, and I want to make Open Hardware Hub a place that inspires others to build, ...
-
Updates 2013 February 18
It's been a while, hasn't it? Well, that's ok because we've got a lot of updates to talk about. Most of these have been effective on the site fora couple weeks now. A few may or may not be active when this article gets posted, but they'll certainly be applied in the ...
Portal Turret Plushie
Files
- Portal_Turret.pde - Portal Turret Arduino Sketch
- PIRSensorTest.pde - PIR Sensor Test Arduino Sketch
- WaveShieldTest.pde - Wave Shield Test Arduino Sketch
- test.wav - Test WAV File
- Pattern Page 1.pdf - Rear and Center Pattern
- Pattern Page 2.pdf - Front Pattern
- Pattern Page 3.pdf - Leg and Leg Cover Pattern
Bill of Materials
This open source hardware project contains no parts.
Steps
. Insert potentiometer
Insert the 10k potentiomter next. Solder it in place. You will have to use a lot of solder to fill the large holes and give it good mechanical strength.
. Insert wires
Take five short pieces of wire, strip them at both ends, and solder them to connect the following pairs of holes on the Wave Shield: 2->LCS, 3->CLK, 4->DI, 5->LAT, 10->CCS. These wires are the ones that are hidden behind the wires connecting the RBBB to the Wave Shield.
. Make jumper wires
Get 8 wires that are about 2 inches long. Make these wires as short as you are comfortable making them. Use them to connect the RBBB to the Wave Shield as detailed in the next couple steps.
. Solder wires
First, connect pins 2, 3, 4, and 5 on the Wave shield to pins D2, D3, D4, and D5 on the RBBB as shown. Solder these wires.
Download steps w/o images
Download steps w/ images
Revisions
15 - added attribution note
14 - updated description
13 - added a couple switches to the parts list
12 - updated steps 52 and 53 to remove "TK" placeholders
11 - added a speaker to the BOM
10 -
9 -
8 -
7 - edited step 130
6 -
5 -
4 -
3 - updated project images.
2 - added youtube link. updated line numbers.
1 - Initial project release
Add revision
blog comments powered by Disqus
Back
